Planar Systems LUX80-ERO-B-T Guía de instalación descargar pdf (Pagina 56)

Planar UltraLux Remote Monitoring

50 Planar UltraLux Series Installation Guide

b You do no need to fill in anything under the Static (non-DHCP) Network

Settings section. However, if you do, these settings will be used in the event

that the DHCP attempts to time out.

c Go to step 6.

5 Under the DHCP section, choose No, use static settings.

a In the Static (non-DHCP) Network Settings section, enter the IP address given

to you by the network administrator.

b Enter the Network mask, DNS server(s), and Gateway as instructed by the

network administrator.

c Go to step 6.

6 Scroll to the bottom of the page and click Confirm and apply new network

settings to receive the Confirm Network Change page.

7 Review the settings to make sure they are correct. Click OK, apply changes now

to receive the Applying Network Changes page. This shows the network settings

to be used.

Note: If you have changed the static IP address or changed from static to DHCP setup, you

may need to point your browser at the new address.

You may have to click the Refresh button on your browser to see the new name

in the upper left corner of the page.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 105 106

Sin comentarios

Planar Systems LUX80-ERO-B-T Guía de instalación Pagina 56