Planar Systems LUX80 Guía de instalación descargar pdf (Pagina 43)

Sending RS232 Commands Via UDP

Planar UltraLux Series Installation Guide 37

Sending RS232 Commands Via UDP

The UDP port 57 accepts the same command sets as RS232. It is convenient for IP

control applications and can be tested with a UDP terminal program such as the

Hercules SETUP utility available from www.HW-group.com

Note: Ensure that the Enable ASCII command service (UDP port 57) box is checked on the

Access Control page of the Remote Monitoring software.

Notice the following in the example below:

• The Module IP address must match the Planar device server’s IP address

•Enter 57 in the Port box.

• “04 21 16 C5” in the Send box corresponds to the Get Power Status RS232

command.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 103 104

Sin comentarios

Planar Systems LUX80 Guía de instalación Pagina 43